How To Clean Out An Old Mascara Tube

Download Article

Download Article

If you recently purchased a lash or eyebrow serum and it didn't come up with an applicator brush, you may be wondering how you can use it without going and buying a completely new product. Since mascara comes with a tube and an applicator wand, they are the perfect storage places for growth serums, every bit long as they are completely make clean. You can spend a single afternoon cleaning out your mascara tube to repurpose it for a fresh new product y'all can use every twenty-four hours.

1. one

   Pull out and clean the mascara wand with warm water and soap. Soak your mascara wand in warm water for ten to 15 minutes. Wash the wand with dish lather and warm water and pat it dry with a newspaper towel.^[one]

2. 

   2

   Pour a water-based makeup remover into the mascara tube. Makeup remover volition help to interruption down all the mascara that is left inside of the tube. Apply an eye makeup remover to make full the tube all the way.^[two]

   • Oil-based removers won't mix well with h2o and may leave a residue in your mascara tube.
   • If y'all don't accept any eye makeup remover, you can besides use rubbing booze.

   Tip: Waterproof mascara tubes are much harder to clean out than normal mascara tubes since they won't pause downwardly with water.

   Advertisement

3. 

   3

   Pump the mascara wand in the tube to loosen the mascara. Put the mascara wand back into the tube and swirl it around a few times. Use the mascara wand to pull some of the loose mascara upwardly and out of the tube if you tin can.^[three]

   • This will also help to clean off the mascara wand in case yous desire to reuse it.

4. 4

   Recap the tube and let the makeup remove soak the interior for iii hours. Close the lid of the mascara tube with the wand inside and allow information technology sit with the makeup remover for at least 3 hours. If you are cleaning out a waterproof mascara tube, let information technology sit overnight.^[4]

   • Letting the tube sit allows the makeup remover to interruption down more than of the mascara inside and makes it easier to clean.

5. 

   5

   Pour the makeup remover out of the tube onto a newspaper towel. Unscrew the wand from the peak of the mascara tube and dump out equally much makeup remover as you tin onto a paper towel. Don't be worried if only a little flake comes out since it could but exist stuck at the bottom of the tube.^[5]

   • Try non to cascade your makeup remover and mascara downward the drain, equally it could clog your sink over time.

6. 

   half dozen

   Check for and remove the rubber insert if your mascara tube has ane. Some mascara tubes have a rubber stopper on the inside of the tube. Use the tines of a fork to pry the safe part out of the tube so you lot tin clean it out.^[6]

   • The prophylactic may accept mascara stuck underneath information technology which is why it is of import to take it out.

   Advert

1. 1

   Submerge your mascara tube and wand in warm water and dish lather. Fill your sink or a minor basin with warm h2o and add i to two drops of dish soap. Swirl the dish soap and water around and so they mix. And then, put your mascara tube and wand into the water and submerge them fully and then that your mascara tube fills up with water.^[7]

   • If you took out the rubber insert, clean that off in the soapy water also.

   Tip: Use grease-fighting dish soap for the best results.

2. 

   2

   Employ the mascara wand to loosen the mascara inside of the tube. Insert the mascara wand into the tube over again and swirl it around. Use the wand to bring chunks of mascara up and out of the tube if you can.^[8]

   • If you lot are pulling out a lot of mascara with your wand still, pour one drop of dish soap directly within the tube and swirl information technology effectually with your mascara wand.

3. 

   3

   Dunk the mascara tube into freshwater to get rid of the lather. Drain the soapy water out of your sink or basin. Refill it with warm, make clean h2o and submerge your mascara tube and wand into it. Exercise this a few times until in that location are no more soap bubbles coming out of your mascara tube.^[9]

   • If you got any mascara on your hands, use some dish soap to wash information technology off.

4. 

   4

   Rinse out the tube and wand with rubbing booze. Pour a small amount of rubbing alcohol into your mascara tube. Close the lid of the tube with the wand inside and shake it back and forth a few times. Drain the rubbing alcohol out of the tube.^[10]

   • Rubbing alcohol sterilizes the mascara tube and wand, which is important if you are repurposing it for a new product.

5. 5

   Let the tube and wand air-dry out in the sun. Go out the mascara tube uncapped and set information technology with the wand in a sunny surface area for about vi hours. Make sure your mascara tube is completely dry out before you lot fill up it with a new production.^[xi]

   • Check that the tube is clean past putting the wand in it and so rubbing the wand over your manus. If any mascara comes off onto your mitt, you need to clean out your mascara tube again.

6. 

   six

   Add new products to your mascara tube if desired. Insert the rubber slice back into the top of your mascara tube. Pour your new products into the mascara tube and use the wand as an applicator.^[12]

   • Most lash eyebrow serums take natural vitamins and minerals that encourage the growth of follicles on your face.

   Advertizing

Ask a Question

200 characters left

Include your email address to go a message when this question is answered.

Submit

Advertisement

VideoRead Video Transcript

• Waterproof mascara tubes are much harder to clean out than non-waterproof ones.

Cheers for submitting a tip for review!

Advertisement

Things You'll Demand

• Heart makeup remover
• Dish soap
• Small basin
• Paper towels
• Rubbing alcohol

About This Article

Commodity Summary X

To clean out an old mascara tube so you can put a new production in it, first past removing the mascara wand and soaking the wand in soapy h2o for 10 minutes. Scrub the wand with your fingers, then pat it dry with a newspaper towel. Next, pour water-based makeup remover into the mascara tube and pump the mascara wand in the tube to loosen the sometime mascara. Recap the tube and permit information technology soak for 3 hours. Then, pour out the makeup remover and pry out the rubber insert with a fork if your mascara tube has ane. Soak the tube and wand in soapy h2o, then use the wand to scrub the inside of the tube. Rinse out the tube with clean water. Finally, rinse out the tube with rubbing alcohol to sterilize it. Let the tube and wand fully air dry before adding your new product. For more than tips, similar how to remove stubborn mascara, proceed reading!

Did this summary help y'all?

Thanks to all authors for creating a page that has been read 54,791 times.

Did this commodity help yous?

Source: https://www.wikihow.com/Clean-Out-a-Mascara-Tube#:~:text=Pour%20a%20small%20amount%20of,it%20for%20a%20new%20product.

Posted by: bensoncourpastruce.blogspot.com

Share this post